TM-9-2320-209-20-3-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4

MAY 1981

TM-9-2320-209-20-3-2 - Page 115 of 552

TM 9-2320-209-20-3- 2

(3) Fittings .

(a) Tube and elbow assembl y

CAUTIO N

Fittings are made of soft brass. They can b e

stripped very easily if tightened too much .

Tighten fittings just enough to stop fluid fro m

leaking .

NOT E

Tube and elbow assembly on air hydraulic cy -

linder is used for this typical procedure .

FRAME 1

1 .

Using 3/4-inch open end wrench , screw in and tighten elbow (1) .

2 .

Using 3/4-inch open end wrench, hold elbow (1). Using 13/16-inc h

combination box and open end box wrench, screw on and tighten tub e

nut (2) .

GO TO FRAME 2

13-10 2