TM-9-2320-209-20-3-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4

MAY 1981

TM-9-2320-209-20-3-2 - Page 117 of 552

TM 9-2320-209-20-3- 2

(b) Multiple tee fittin g

CAUTIO N

Fittings are made of soft brass. They can b e

stripped very easily if tightened too much .

Tighten fittings just enough to stop fluid fro m

leaking .

NOT E

Multiple tee fitting on brake hydraulic line o n

the rear axle is used for this typical procedure .

FRAME 1

1 .

Put multiple tee fitting (1) into place and aline screw holes .

2 .

Using 9/16-inch open end wrench, put in and hold capscrew (2). Usin g

9/16-inch open end wrench , screw on and tighten self-locking nut (3) .

3 .

Using 7/8-inch open end wrench, hold multiple tee fitting (1). Usin g

7/16-inch combination box and open end box wrench, screw on and tighte n

two tube nuts (4) .

GO TO FRAME 2

13-10 4