TM-9-2320-209-20-3-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4

MAY 1981

  TM-9-2320-209-20-3-2 - Page 110 of 552

TM 9-2320-209-20-3- 2
b .
Replacement .
(1) Hydraulic lines and clamps .
CAUTIO N
Fittings are made of soft brass. They can b e
stripped very easily if tightened too much .
Tighten fittings just enough to stop fluid fro m
leaking .
NOT E
Hydraulic brake line on left rear axle is use d
for this typical procedure .
FRAME 1
1 .
Using 9/16-inch open end wrench, hold multiple connector (1). Using 7/16 -
inch combination box and open end box wrench, screw in and tighten tub e
nut (2) .
GO TO FRAME 2
13-9 7


Back to Top