TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 261 of 592

TM 9-2320-209-34-2-3

f.

Assembly.

FRAME 1

1.

Put bearing (1) on shaft (2) with 3/4 inch between nut side of bearing and threaded

end of shaft.

2.

Put nut (3) on shaft (2) against bearing (1).

3.

Put in cotter pin (4).

CAUTION

Make sure that end of key (5) is not touching inner race of

bearing (1).

4.

Put key (5) into keyway of shaft (2).

5.

Place gears (6 and 7) inside housing (8) as shown.

6.

Put shaft (2) into housing (8). Align key (5) in shaft (2) with keyway in

gears (6 and 7). Tap nut end of shaft (2) with soft-faced hammer until

bearing (1) goes into housing (8).

NOTE

Position shaft (2) in housing (8) so that front side of gear

(7) is seated against housing.

7.

Tap shaft (2) to seat bearing (1) against nut (3).

GO TO FRAME 2

18-250