TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 263 of 592

TM 9-2320-209-34-2-3

FRAME 3

1.

Put key (1) in keywayof shaft (2).

2.

Align keyway in sprocket (3) with key (1). Tap sprocket (3) over key until end of

sprocket touches inner race of bearing (4).

3.

With end of sprocket (3) against bearing (4), tap sprocket end of shaft (2) to make

sure that other bearing is seated against bearing cap (5).

4.

Put washer (6) and nut (7) on shaft (2).

NOTE

End play is the amount that shaft moves from end to end or

side to side.

5.

Check that shaft (2) has only 0.005 inch end play. If needed, take off bearing cap (9)

and add or take off shims (10) until end play is 0.005 inch.

6.

Put in cotter pin (8).

GO TO FRAME 4

18-252