TM-9-2320-272-24-2

TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL; VOLUME 2 OF 4

JUNE 1998

TM-9-2320-272-24-2 - Page 238 of 991

TM 9-2320-272-24-2

3-331. REAR WINCH CABLE REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

EQUIPMENT CONDITION

M936/A1/A2

l

Parking brake set (TM 9-2320-272-10).

TOOLS

l

Rear winch cable unwound (TM 9-2320-272-10).

General mechanic ’s tool kit (Appendix E, Item 1)

GENERAL SAFETY INSTRUCTIONS

REFERENCES (TM)

Wear hand protection when handling winch cable.

TM 9-2320-272-10

TM 9-2320-272-24P

a. Removal

WARNING

Wear hand protection when handling winch cable. Broken wires

may cause injury to personnel.

1.

Remove setscrew (4) and cable (2) from hole (3) in winch drum (1).

2.

Pull cable (2) out over level wind pulley (9), down through tensioner sheaves (6), and out of rollers (8),

and side of rollers (7).

b. Installation

1.

Thread cable (2) into center of side rollers (7), rollers (8), tensioner sheaves (6), under level wind

pulley plate (5), and over level wind pulley (9).

2.

Insert cable (2) in hole (3) of winch drum (1) and install setscrew (4).

FOLLOW-ON TASK: Wind winch cable on drum (TM 9-2320-272-10).

3-846