TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 367 of 801

TM 9-2320-273-34

NOTE

During assembly, make sure the gear and bear-

ings are properly seated to assure correct bearing

adjustment after shaft is enclosed inside of case.

(4) Set the bearing cone over the end of the intermediate shaft. Press until it is firmly seated

against the shaft shoulder (fig. 8-37).

TA 074230

Figure 8-37

(5)

Set the bearing cup over

against the bearing rollers (fig. 8-38).

(6) Turn the case over.

(7)

Front Intermediate Bearing Installation.

the bearing cone and press until the bearing cup is firmly seated

Install the rear bearing cone and cup the same way the front were installed.

Figure 8-38 Bearing Cup Installation.

TA 074231

8-27