TM-9-2320-273-34
TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1980
TM-9-2320-273-34 - Page 371 of 801
TM 9-2320-273-34
NOTE
It is recommended that the gear be preheated
by soaking in 150
0
F (66
0
C) oil and the shaft
surface be prelubricated with molybdenum
disulfide base lubricant to facilitate assembly.
(2) With the yoke end of the shaft down, insert the lock key into the shaft with the rounded
end of the key in the shaft shoulder.
(3) press the shaft and key onto the gear until the shaft shoulder is firmly seated against the
gear face (fig. 8-44).
Figure
8-44.
Lower Rear Output Shaft Gear Installation.
(4) with the
yoke end of the shaft up, install the spacer over the shaft.
(5) press the cover and bearing onto the shaft until it is firmly seated (fig. 8-45).
TA 074428
TA 074429
Figure
8-45
Lower Rear Output Shaft Rear Bearing Installation.
8-31
Back to Top
