TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 416 of 801

TM 9-2320-273-34

(2)

Remove the oil slinger and brake assembly. If brake maintenance is required, refer to

TM 9-2320-273-20. If dust shields are to be removed or replaced, remove two capscrews and washers

on each shield and remove.

NOTE

In step

(3),

the spindle, inner sleeve, felt

seal and retainer assembly, the outer

drive shaft oil seal wiper, and the outer shaft

thrust washer will remain seated inside

the spindle. Remove only if required; use

a suitable pointed tool for removal.

(3)

PuII the spindle straight out from the knuckle and outer drive shaft (fig. 10-6). Remove

and replace grease fitting if damaged.

Figure 10-6. Remove Spindle.

10-8