TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 418 of 801

TM 9-2320-273-34

NOTE

It is not necessary to disassemble both

cross tube ends unless both knuckle

assemblies are being serviced at the

same time,

(3)

Remove knuckle upper sleeve (fig. 10-8) from the knuckle by first removing four sleeve to

knuckle capscrews and Iockwasher. Lift off the upper sleeve from the knuckle bore. The knuckle upper

bearing cone will remain seated on the sleeve and comes off at the same time. Remove the bearing cone

from the sleeve if required, using a suitable puller. Replace upper and lower grease fittings if damaged.

Figure 10-8. Remove Upper and Lower Sleeves.

(4)

Remove steering arm by removing cotter pin and nut, then drive out of upper sleeve with

mallet and remove key.

10-10