TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 426 of 801

TM 9-2320-273-34

(9)

Remove spider, spider pinions, side gears, and thrust washers (fig.10-17).

(10)

If ring gear is to be replaced for any reason, remove capscrews, nuts, and washers, then

separate gear from case.

(11)

If necessary to replace differential bearings, remove with a suitable puller.

c.

Remove Pinion and Cage Assembly.

(1)

Hold the yoke with suitable tool and remove pinion shaft nut and washer.

(2)

Remove yoke with a suitable puller.

(3)

Remove the pinion cage capscrews and washers.

(4)

Remove the bearing cover and

The use of a

oil seal assembly.

CAUTIO N

pinch bar will damage the shims.

Driving pinion from inner end with a drift will

damage the bearing lock ring groove.

(5)

Remove the bearing cage. Original may have jacking screw holes as shown in figure 10-18.

Figure 10-18. Remove Bearing Cage.

10-18