TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 415 of 801

TM 9-2320-273-34

(1)

If the hub seal and inner bearing cone are still seated in the hub, remove by using a long

screwdriver or other pointed tool to pry loose. Replace the seal at reassembly.

(2)

If necessary, remove inner and outer bearing cups from the hub, using a press and sleeve

or suitable bearing puller.

In step

d,

if a press is not available, a

brass hammer or drift may be used to

drive out the studs. Do not strike wheel

studs with a steel hammer or attempt to

twist to remove – damage will result.

d.

Remove Drum and Wheel Studs.

If necessary, remove wheel studs from hub by placing hub in a

hydraulic press, drum side up, and press out.

e.

Disassemble Spindle, Brake Assembly and Oil Slinger from Knuckle.

(1)

Disassemble the hub oil slinger, brake assembly, and wheel spindle from the steering knuckle

by removing the eight attaching capscrews and Iockwasher (fig. 10-5). It may be necessary to pry spring

aside (but do not remove) and position wrench socket on heads of some capscrews.

Figure 10-5. Disassemble Hub Oil Slinger, Brake Assembly, and Wheel Spindle.

10-7

CAUTIO N