TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 169 of 1390

TM 9-2320-328-13&P-2

0121-17

DRAFT

0121

Change 1

END OF TASK

.

HWT1474

.

Step 24.

Cut main wire harness stowage compartment striplight butt splice connector.

Check for

continuity across main wire harness wire 1479 (black) from main stowage compartment

P2 striplight connector termination to passenger side front stowage compartment P2

door switch connector.

.

If there is no continuity, repair wire 1472 in main wire harness if repairable

(TM 9-2320-325-14&P), or replace main wire harness (WP 0292).

.

WARNING

.

ICON 3

.

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment, or

severe burns or electrical shock to personnel.

.

Step 25.

Cut main wire harness wire 1189 at non-operating passenger side stowage

compartment P2 striplight butt splice connector.

Push battery disconnect switch to on

position (WP 0007).

Turn Service Drive Lights On (TM 9-2320-422-10).

Check for 22

to 28 VDC between wire 1189 (red) at main wire harness stowage compartment

striplight connector termination and a known good ground.

.

a.

If 22 to 28 VDC are present, replace stowage compartment striplight

(WP 0215).

.

b.

If 22 to 28 VDC are not present, repair wire 1189 in main wire harness if

repairable (TM 9-2320-325-14&P), or replace main wire harness

(WP 0292).

.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION