TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 175 of 1390

TM 9-2320-328-13&P-2

0122-5

DRAFT

0122

HWT0698

WARNING

ICON 3

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment, or

severe burns or electrical shock to personnel.

Step 9.

Disconnect pump house wire harness striplight connector from either driver side pump

house striplight.

With a test lead set, check for 22 to 28 VDC between pump house wire

harness wire 1661 (black) at driver side striplight connector, terminal A and a known

good ground.

If 22 to 28 VDC are not present, repair wire 1661 in pump house wire

harness if repairable (TM 9-2320-325-14&P), or replace pump house wire

harness (WP 0302).

Step 10.

Put pump operator’s panel PANEL LIGHTS switch to off position (WP 0004).

Pull

battery disconnect switch to off position (WP 0007).

With a test lead set, check for

continuity across pump house wire harness wire 2740 (black) from driver side striplight

connector, terminal B to a known good ground.

a.

If there is continuity, replace pump house striplight (WP 0215).

b.

If there is no continuity, repair wire 2740 in pump house wire harness if

repairable (TM 9-2320-325-14&P), or replace pump house wire

harness (WP 0302).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION