TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 173 of 1390

TM 9-2320-328-13&P-2

0122-3

DRAFT

0122

Step 4.

Put pump operator’s panel PANEL LIGHTS switch to off position (WP 0004).

Pull

battery disconnect switch to off position (WP 0007).

Cut wire 3895 (black) in pump

operator’s panel wire harness striplight butt splice connector from non-operating pump

operator’s panel striplight.

Check for continuity across pump operator’s panel wire

harness wire 3895 (black) from striplight butt splice connector termination to a known

good ground.

a.

If there is continuity, replace non-operating pump operator’s panel

striplight (WP 0215).

b.

If there is no continuity, repair wire 3895 in pump operator’s panel wire

harness if repairable (TM 9-2320-325-14&P), or replace pump

operator’s panel wire harness (WP 0303).

Step 5.

Open pump house access door assembly (WP 0009).

Open driver side pump house

control access door (WP 0008).

Check if both driver side pump house striplights

operate.

If driver side pump house striplights do not operate, go to Step 8.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION