TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 937 of 1390

TM 9-2320-328-13&P-2

0264-3

DRAFT

0264

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

9.

Remove four nuts (19), lockwashers (20), eight washers (21), screws (22), and bracket (18) from pump house

frame (23).

Discard lockwashers.

END OF TASK

INSTALLATION

NOTE

Perform Steps (1) and (2) if bracket was removed.

1.

Install bracket (18) on pump house frame (23) with four screws (22), eight washers (21), four

lockwashers (20), and nuts (19).

2.

Install shutoff control valve manifold (WP 0270).

NOTE

Perform Steps (3) and (4) if pump house power distribution wire harness and block and

pass-through terminal blocks need to be installed on power distribution box.

3.

Install two pass-through terminal blocks (WP 0241).

4.

Install pump house power distribution wire harness and block (WP 0299).

5.

Install distribution box (17) on bracket (18) with four screws (16), eight washers (15), four lockwashers (14),

and nuts (13).

HWT2810