TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 473 of 1207
TM 9-2320-361-20
4-41. FRONT COMPOSITE LAMPS, HOUSING, AND BRACKETE REPLACEMENT
This task covers:
a. Composite Lamps Removal
c. Composite Light Housing Installation
b. Composite Light Housing Removal
d. Composite Lamps Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Two lockwashers
EQUIPMENT CONDITION
Four locknuts
Parking brake set (TM 9-2320-361-10).
Gasket
Battery ground cable disconnected. (para. 4-48).
Intermediate turn signal removed, if equipped
(para. 4-40).
a. Composite Lamps Removal
1. Loosen five screws (2) and remove lens cover (1) and gasket (16) from composite light housing (4).
Discard gasket (16).
2. Remove lamp(s) (3) from composite light housing (4).
I
b. Composite Light Housing Removal
NOTE
Tag all wires for installation.
1. Disconnect three wires (6) from wires (5).
2. Remove two screws (7), lockwashers (8), and composite light housing (4) from upper bracket (15).
Discard lockwashers (8).
3. Remove four locknuts (13), screws (14), lower bracket (11), and upper bracket (15) from fender (10).
Discard locknuts (13).
4. Remove two grommets (9) and (12) from fender (10) and lower bracket (11).
c. Composite Light Housing Installation
1.
Install grommets (9) and (12) on fender (10) and lower bracket (11).
2. Install upper bracket (15) and lower bracket (11) on fender (10) with four screws (14) and new
locknuts (13).
3. Install composite light housing (4) on upper bracket (15) with two new lockwashers (8) and
screws (7).
4. Connect three wires (6) to three wires (5).
d. Composite Lamps Installation
1. Install lamp(s) (3) in composite light housing (4).
2. Install new gasket (16) and lens cover (1) and tighten five screws (2).
4-62
Back to Top
