TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 477 of 1207
TM 9-2320-361-20
4-43. FLOODLAMP HOUSING AND MOUNT MAINTENANCE
This task covers:
a. Floodlamp Housing and Mount Removal
c. Floodlamp Housing and Mount Assembly
b. Floodlamp Housing and Mount Disassembly
d. Floodlamp Housing and Mount Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M756A2
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Four lockwashers
EQUIPMENT CONDITION
●
Parking brake set (TM 9-2320-361-10).
●
Battery ground cable disconnected (para. 4-48).
●
Floodlamp removed (para. 4-44).
a. Floodlamp Housing and Mount Removal
NOTE
Tag all wires for installation.
1. Disconnect two wires (11) from connectors (1).
2. Remove handle (6) from cab protector (10) and remove floodlamp housing (2) and floodlamp housing
mount (5).
I
b. Floodlamp Housing and Mount Disassembly
1.
2.
3.
4.
5.
6.
7.
Remove two nuts (7) and (8), washer (9), floodlamp housing bracket (3), and washer (4) from
floodlamp housing mount (5).
Remove two nuts (13), lockwashers (14), and washers (15) from screws (30). Discard lock-
washers (14).
Remove two screws (30), washers (29), four spring washers (28), two washers (27), floodlamp
housing bracket (3), two washers (26), spacers (20), and grommet (19) from floodlamp housing (2).
Disconnect wires (12) and (22) from two connectors (1).
Remove two screws (17), lockwashers (18), and switch (23) from floodlamp housing (2). Discard
lockwashers (18).
Remove two screws (25), retainer (24), and switch top (23) from bottom of switch (21).
Remove two connectors (1) and grommets (16) from floodlamp housing (2).
c. Floodlamp Housing and Mount Assembly
1.
2.
3.
4.
5.
6.
7.
8.
4-66
Install two grommets (16) and connectors (1) in floodlamp housing (2).
Install switch top (23), retainer (24), and two screws (25) in switch bottom (21).
Install switch (21), two new lockwashers (18), and screws (17) in floodlamp housing (2).
Connect two wires (12) and (22) to connectors (1).
Install two grommets (19) and spacers (20) on floodlamp housing (2).
Position floodlamp housing (2) and two washers (26) on floodlamp housing bracket (3) and install
with two washers (27), four spring washers (28), two washers (29), and screws (30).
Install two washers (15), new lockwashers (14), and nuts (13) to screws (30).
Install washer (4) with floodlamp housing bracket (3), washer (9), and two nuts (8) and (7) to
floodlamp housing mount (5).
Back to Top
