TM-9-2320-361-20

TM 9-2320-361-20

11-20. WINDSHIELD ASSEMBLY MAINTENANCE (Contd)

1. Install upper left hinge (22) on lower left hinge (17) with hinge bolt (16) and nut (19).

2. Install stud (20) and knob (11) in upper left hinge (22). Do not tighten knobs (11) if vehicle is

equipped with hardtop kit.

d. Installation

1. Apply adhesive to mounting side of new weatherstrip (1) and windshield frame (5) mounting

surface. Install weatherstrip (1) on windshield frame (5) mounting surface.

2. Install two new weatherstrips (12) and plates (13) on two brackets (15) with four screws (14).

3. Install two brackets (15) on windshield frame (5) with four screws (10).

NOTE

Two lower hinges are attached to cab by six screw-assembled

lockwashers. Exhaust support is attached to lower right hinge

and cab by a longer screw and lockwasher.

Assistant will help with step 4.

4. Install windshield frame (5) in place on cab (9) and install hinges (22) and (24) on windshield

frame (5) with six new screw-assembled lockwashers (21).

5. Install lower right hinge (23) on exhaust support (28) and cab (9) with new lockwasher (25) and

screw (26).

6. Install lower right hinge (23) on cab (9) with six new screw-assembled lockwashers (27).

NOTE

Perform steps 7 through 9 on vehicles equipped with hardtop kit.

7. Tighten knobs (11) against hinges (22) and (24).

8. Install cab hardtop (6) on windshield frame (5) with two screws (2), washers (3), and new lock-

nuts (4).

9. Install cab hardtop (6) on windshield frame (5) with two screws (8) and new lockwashers (7).

11-32

TM-9-2320-361-20 - Page 729 of 1207