TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 735 of 1207

TM 9-2320-361-20

11-23. REAR CAB MOUNT REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

REFERENCES (TM)

All

TM 9-2320-361-10

MATERIALS/PARTS

TM 9-2320-361-20P

Two locknuts

PERSONNEL REQUIRED

Two

EQUIPMENT CONDITION

Parking brake set (TM 9-2320-361-10).

Spare tire removed (M342A2 only)

(TM 9-2320-361-10).

GENERAL SAFETY INSTRUCTIONS

Support cab while replacing mount.

Do not place fingers between frame and

crossmember.

WARNING

Do not place fingers between frame and crossmember while

replacing mount. Doing so may result in injury to personnel.

NOTE

Assistant will help with entire procedure.

1. Remove two rear cab mount locknuts (9), washers (8), screws (2), springs (4), and four washers (3)

from bracket (5) and frame (7). Discard locknuts (9).

WARNING

Support cab body while in raised position for mount replacement.

Failure to do so may result in injury to personnel.

CAUTION

Do not raise rear of cab too high when removing mounts. Damage to

cab may result.

2. Raise cab (1) to provide clearance and remove two mounts (6) from frame (7).

I

b. Installation

I

1. Install two new mounts (6) on frame (7).

2. Lower cab (1) on mounts (6).

3. Install two springs (4) and four washers (3) on two screws (2) and install screws (2) through

bracket (5), mounts (6), and frame (7).

4. Install two washers (8) and two new locknuts (9) on screws (2). Tighten locknuts (9) to compress

springs (4) to height of 1.78 in. (4.52 cm).

11-38