TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 727 of 1207
TM 9-2320-361-20
11-20. WINDSHIELD ASSEMBLY MAINTENANCE
This task covers:
b. Disassembly
a.
Removal
c. Assembly
d. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Three lockwashers
EQUIPMENT CONDITION
Two locknuts
Eighteen screw-assembled lockwashers
Parking brake set (TM 9-2320-361-10).
Three weatherstrips
Soft top removed (TM 9-2320-361-10).
Adhesive (Appendix C, Item 2)
Wiper motors removed (para. 11-34).
a. Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
NOTE
Perform steps 1 through 3 for vehicles equipped with hardtop kit.
Remove two screws (8) and lockwashers (7) from cab hardtop (6) and windshield frame (5).
lockwashers (7).
Remove two screws (2), washers (3), and locknuts (4) from cab hardtop (6) and windshield
frame (5). Discard locknuts (4).
Loosen two knobs (11).
NOTE
Two lower hinges are attached to cab by six screw-assembled
lockwashers. Exhaust support is attached to lower right hinge and
cab by a longer screw and lockwasher.
Assistant will help with step 4.
Discard
Remove six screw-assembled lockwashers (21) and windshield frame (5) from left (22) and right (24)
upper hinges and cab (9). Discard screw-assembled lockwashers (21).
Remove six screw-assembled lockwashers (18) and lower left hinge (17) from cab (9). Discard screw-
assembled lockwashers (18).
Remove six screw-assembled lockwashers (27) from lower right hinge (23) and cab (9). Discard
screw-assembled lockwashers (27).
Remove screw (26), lockwasher (25), and lower right hinge (23) from exhaust support (28) and
cab (9). Discard lockwasher (25).
Remove four screws (10) and two brackets (15) from windshield frame (5).
Remove four screws (14), two plates (13), and weatherstrips (12) from two brackets (15). Discard
weatherstrips (12).
Remove weatherstrip (1) from windshield frame (5). Discard weatherstrip (1). Clean windshield
frame (5) free of all weatherstrip (1) remains.
1. Remove knob (11) and stud (20) from upper left hinge (22).
2. Remove nut (19), hinge bolt (16), and upper left hinge (22) from lower left hinge (17).
11-30
Back to Top
