TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 731 of 1207
TM 9-2320-361-20
11-21. WINDSHIELD ARM, GLASS, AND HANDLE REPLACEMENT
This task covers:
a. Arm RemovaI
d. Handle Installation
b. Glass Removal
e. Glass Installation
c. Handle Removal
f. Arm Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
Nine screw-assembled lockwashers
Three seals
Bumper
Adhesive (Appendix C, Item 3)
TM 9-2320-361-20P
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-361-10).
Wiper motors removed (para. 11-34).
a. Arm Removal
Remove two screws (8) and spring washers (9) from arm (11), outer frame bracket (5), lever (12), and
glass frame bracket (10).
b. Glass Removal
1. Remove seven screw-assembled lockwashers (18) from windshield hinge (3) and windshield outer
frame (4). Discard screw-assembled lockwashers (18).
2. Remove two hinge seals (1) and (2) from windshield hinge (3). Remove seal (13) from windshield
inner frame (19). Discard seals (1), (2), and (13).
c. Handle Removal
1. Remove two screws (17), nuts (15), and handle (14) from windshield inner frame (19).
2. Remove bumper (16) from handle (14). Discard bumper (16).
3. Remove two screw-assembled lockwashers (6) and plate (7) from windshield outer frame (4). Discard
screw-assembled lockwashers (6).
d. Handle Installation
1. Install new bumper (16) in handle (14).
2. Install handle (14) on windshield inner frame (19) with two screws (17) and nuts (15).
3. Install plate (7) on windshield outer frame (4) with two new screw-assembled lockwashers (6).
11-34
Back to Top
