TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 589 of 764
TM 9-2320-361-34
16-4. REAR WINCH REPAIR (M764)
(Contd)
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
33.
34.
35.
36.
37.
38.
39.
Install stud (37) on worm gear
(19).
Install brake stop (39) on stud (37) with new pin (38).
Install two nuts (35) on two studs (36).
Install two studs (36) on worm gear housing (17) and tighten two nuts (35) to worm gear housing
(17).
Position brake nut (6) and pin
(40)
on worm gear
(19).
Apply light coat of sealing compound to front and back sides of new gasket (5).
Install new gasket (5) and washer (4) on brake nut (6) with two new lockwashers (3) and screws (2).
Install four springs (11), washers (10), and screws (9) in thimbles (12) with four new cotter pins (13).
Position lining
(41),
plate
(42),
lining (1), and plate
(43)
on brake nut (6) and two studs (36).
Install two springs (8) in two thimbles (7).
Install four nuts
(15)
on four screws (9).
Position two thimbles (7) in plate
(14).
Install plate
(14)
on brake nut (6) with four screws (9). Tighten four nuts
(15) to
worm gear housing (17).
Install new seal (20) in worm gear housing (17) with plate (21), four new lockwashers (33), and
screws (32).
Install spacer (22), four shims (23), new woodruff key (18), sleeve (24), and sprocket (27) on worm
gear (19) with pin (25) and two new cotter pins (26).
Install retaining ring (28) on sleeve (24).
Install grease fitting
(31)
on sprocket (27).
Install new lockwasher (29) and screw (30) on worm gear (19). Tighten screw (30) 200-225 lb-ft
(271-305 N.m).
Install plug (34) and two plugs
(16)
in worm gear housing (17).
16-46
Back to Top
