TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 631 of 764
TM 9-2320-361-34
16-16. POWER DIVIDER REPAIR (M764)
(Contd)
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
Install two new packings (8) and (9) on straight rod (7) and housing (27).
Install plate (10) on housing (27) with four new lockwashers (16) and screws (15).
Install jamnut (13) on eyebolt (14).
NOTE
Prior to tightening jamnut, aline eyebolt with scribe mark.
Install new lockwasher (12) and eyebolt (14) on shifter rod (11) and tighten jamnut (13).
NOTE
Prior to tightening janmut, aline shifter rod with scribe mark.
Position shifter rod (11) through new packing (9) and install jamnut (4) on shifter rod (11) and
install new lockwasher (5) and shifter rod (11) on shifter fork (6).
Install spacer (20) and bearing (19) on input shaft (17).
Position gear (26) in shifter fork (6) and install input shaft (17) through gear (26) and housing (27).
NOTE
Step
22
establishes shim pack starting thickness.
Place cap (22) on housing (27) and measure distance between cap (22) and housing (27).
Remove cap (22) from housing (27) and install new seal (23) in cap (22).
NOTE
Use measurement obtained in step 22 plus a 0.015 in. (0.381 mm)
shim for starting shim pack thickness.
Install spacer (18) on input shaft (17). Install shim(s) (21) and cap (22) on housing (27) with four new
lockwashers (25) and screws (24).
Install bearing (28), spacers (29) and (30), bearing (31), and spacer (32) on output shaft (33).
Install output shaft (33) in housing (27) and input shaft (17).
NOTE
Step
27
establishes shim pack starting thickness.
Place cap (35) on housing (27) and measure distance between cap (35) and housing (27).
Remove cap (35) from housing (27) and install new seal (36) in cap (35).
NOTE
Use measurement obtained in step 27 plus a 0.015 in. (0.381 mm)
shim for starting shim pack thickness.
Install new shim(s) (34) and cap (35) on housing (27) with four new lockwashers (38) and
screws (37).
Install two pins (40), new gasket (3), and cover (41) on housing (27) with eight new lockwashers (2)
and screws (1).
Install three plugs (39) in housing (27) and cover (41).
Install bushings (44) and (43) and breather (42) on housing (27).
16-88
Back to Top
