TM-9-2320-366-20-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-2 - Page 637 of 1632
TM 9-2320-366-20-2
TM 9-2320-366-20-2
TM 9-2320-366-20-2
TM 9-2320-366-20-2
TM 9-2320-366-20-2
2-1459
2-1459
2-1459
2-1459
2-1459
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
Remote Control Box
Switch Position
2
3
4
6
8
Underlift fold up
Stinger in
Underlift up
Main winch LH in
Main winch RH in
Main winch RH out
17
16
15
13
11
12
Main winch speed RH high
Main winch LH out
14
Main winch speed LH high
Underlift down
Stinger out
Underlift fold down
TB No.
ACTUATOR NAME
UP
IN
UP
IN
IN
OUT
HIGH
OUT
HIGH
DOWN
OUT
DOWN
TABLE 2-13. ACTUATOR VOLTAGE TEST
(1)
Connect wrecker remote control cable to RH
remote control bulkhead connector
(TM 9-2320-366-10-1).
(2)
Set multimeter to vdc.
(3)
Connect positive (+) probe of multimeter to
terminal listed in Table 2-13. Actuator
Voltage Test.
(4)
Connect negative (-) probe of multimeter on
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1).
(6)
Position remote control box switch to position
listed in Table 2-13. Actuator Voltage Test
and note reading on multimeter.
(7)
If 24 vdc is not present, go to step 3 of this
fault.
(8)
Position master power switch to off
(TM 9-2320-366-10-1).
(9)
Disconnect remote control cable from RH
remote control bulkhead connector
(TM 9-2320-366-10-1).
Back to Top
