TM-9-2320-366-34-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-2 - Page 496 of 1434

TM 9-2320-366-34-2

8-14

Change 2

8-4.

M1086/M1089 INTERMEDIATE FRONT DRIVE SHAFT AND COUPLER BEARING

REPLACEMENT/REPAIR (CONT)

d. Installation.

(1)

Install two grease fittings (1) in universal joint (2).

(2)

Position universal joint (2) in intermediate front

drive yoke (3) with two bearing cups (4) and four

screws (5).

WARNING

CAUTION

Do not use steel hammers to seat bearing

cups in drive yokes.

Failure to comply

may result in injury to personnel or

damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply

may result in damage to equipment.

NOTE

Wipe end of yoke bearing bores prior to

installation.

NOTE

There are two types of bearing cups,

those with tabs and those without.

Perform the following step on bearing

cups not equipped with tabs.