TM-9-2320-387-24-2
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-2 - Page 22 of 1555
NOTE
• If only rubber latch is to be replaced, spring pin does not have
to be completely out of base.
• M1114 vehicles are equipped with plusnuts/tapping blocks
instead of nuts and washers.
1.
Remove two locknuts (6), washers (4), capscrews (3), washers (4), and base (7) from body (5).
Discard locknuts (6).
2.
Remove spring pin (2) and latch (10) from base (7). Discard spring pin (2).
Remove cotter pin (1), pin (8), two rollers (9), and hood latch (11) from latch (10). Discard cotter pin (1).
b. Disassembly
a. Removal
TM 9-2320-387-24-2
Change 1
10-7
10-5. HOOD LATCH MAINTENANCE
This task covers:
a. Removal
c.
Assembly
b. Disassembly
d. Installation
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Hood raised and secured (TM 9-2320-387-10).
Maintenance Level
Unit
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Two locknuts (Appendix G, Item 109)
Cotter pin (Appendix G, Item 29)
Spring pin (Appendix G, Item 450)
Sealing compound (Appendix C, Item 72.1)
1
2
3
4
5
4
6
7
8
9
10
11
9
Back to Top
