TM-9-2320-387-24-2
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-2 - Page 30 of 1555
TM 9-2320-387-24.2
10-9.
HOOD AND HINGE MAINTENANCE
(Cont’d)
1
2.
Remove two cotter pins (41, washers (61, hinge pins (161, and washers (15) from upper hinge
halves (14) and lower hinge halves (11). Discard cotter pins (4).
3.
Remove cotter pin (201, washer (211, hood prop rod (231, and washer (22) from hood (19). Discard
cotter pin (20).
4.
Remove hood (19).
NOTE
l
Perform steps 5 and 6 if replacing hinges.
l
Note position of hinge halves prior to removal for installation.
5.
Remove four locknuts (31, washers (18), capscrews (121, washers (13), and two upper hinge
halves (14) from hood brackets (17). Discard locknuts (3).
(7), and two lower hinge halves
(1
6.
Remove four locknuts (9), washers (lo), capscrews (51, washers
from headlight housing (8). Discard locknuts (9).
1)
Back to Top
