TM-9-2320-387-24-2
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-2 - Page 26 of 1555
Change 1
10-11
TM 9-2320-387-24-2
10-7. HOOD LATCH TAPPING BLOCK REPLACEMENT
This task covers:
a. Removal
b. Installation
Equipment Condition
• Hood latch removed (para. 10-5).
• Side hood stop removed (para. 10-11).
Maintenance Level
Unit
NOTE
For instructions on replacement of rivets, refer to para. 10-56.
Remove two rivets (2) and tapping block (1) from body (3).
1.
If new tapping block (1) is being installed, drill two 3/16-in. (4.8-mm) diameter rivet holes (4) through
body (3) and tapping block (1).
2.
Install tapping block (1) on body (3) with two rivets (2).
b. Installation
a. Removal
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-387-24P
FOLLOW-ON TASKS: • Install side hood stop (para. 10-11).
• Install hood latch (para. 10-5).
1
2
~
3
4
4
Back to Top
