TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 118 of 1616

TM 9-2320-440-13&P

0016-16

0016

c.

LHS Auxiliary Slave Hydraulics Operation (Auxiliary [Slave] Hydraulics).

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

CAUTION

The HEMTT THAAD LHS is only designed to load/unload MRP in AUTO mode.

Extreme caution must be used when operating LHS in MANUAL mode.

Failure to

comply may result in damage to equipment.

NOTE

•

This procedure can only be used if there are no leaks or breaks in hydraulic system.

•

This procedure is used to lower the LHS on a vehicle with a failed hydraulic pump or other

failure which prevents operation of hydraulic system.

•

Each vehicle is equipped with one hydraulic slave hose.

Two hoses (one from each

vehicle) are required to perform slave hydraulics.

Remove hoses from stowage boxes of

vehicles.

1.

Move vehicles into position so main manifold control box (1) on both vehicles are side by side.

2.

Park both vehicles (

3.

Shut off both engines (

CAUTION

Remove hydraulic reservoir tank cap from operable vehicle prior to starting

operation to allow excess hydraulic oil to drain.

Failure to comply may result in

damage to equipment.

4.

Remove hydraulic reservoir cap from operable vehicle.

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

THAAD0478

TM 9-2320-347-10)

TM 9-2320-347-10)