TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 111 of 1616

TM 9-2320-440-13&P

0016-9

0016

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

CAUTION

•

Hydraulic selector switch must remain in MAN TRANSIT position while vehicle is

traveling. Failure to comply may result in damage to equipment.

•

Engine speed must be at idle before using hydraulic selector switch.

Failure to

comply may result damage to equipment.

38.

Turn hydraulic selector switch (6) to MAN TRANSIT position.

39.

Move PTO ENGAGE switch (4) to OFF position. Make sure indicator light (5) is extinguished.

WARNING

•

When loaded with MRP, the center of gravity is moved up and toward rear of

vehicle. Extreme caution must be taken when turning and ascending or descending

on a grade. Failure to comply may result in serious injury or death to personnel.

•

Maximum side slope while operating a HEMTT THAAD loaded with a MRP is 20

percent.

Failure to comply may result in injury or death to personnel.

•

Do not reduce tire pressure when loaded with MRP. Highway tire pressure, 60 psi

(414 kPa) front and 83 psi (572 kPa) rear, is required at all times when loaded with

MRP. Failure to comply may result in damage to equipment and/or severe injury or

death to personnel.

40.

Connect MRP to vehicle ground cable.

41.

Disconnect vehicle static reel clamp (15) from ground rod.

42.

Disconnect MRP static reel clamp from ground rod (refer to THAAD Launcher IETM).

43.

Connect umbilical and ADU/IL cables (Refer to THAAD Launcher IETM).

44.

Refer to WP 0006 if preparing to transport MRP over the road.

END OF TASK

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

- -

-

-

-

-

-

-

-

-

-

-

THAAD0279