TM-9-2320-440-13-P
TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
AUGUST 2010
TM-9-2320-440-13-P - Page 105 of 1616
TM 9-2320-440-13&P
0016-3
0016
NOTE
Loading and unloading times are controlled by engine speed.
Engine speed can be
increased to 1,500 rpm to reduce loading and unloading times.
12.
Move joystick (7) to UNLOAD position and hold until hook arm cylinders (8) are fully extended.
13.
Release joystick (7).
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
CAUTION
•
Engine speed must be at idle before using hydraulic selector switch.
Failure to
comply may result in damage to equipment.
•
Ensure that main frame cylinders do not complete full extension while operating at
engine speeds above idle.
Failure to comply may result in damage to equipment.
•
Manual mode is used mainly in event of a failure of automatic control electrical
system.
Caution must be exercised during operation of MANUAL mode for correct
cycle of events to occur.
Failure to comply may result in damage to equipment.
•
If LHS had previously been used in manual mode and not completely stowed in
AUTO mode, the hook arm cylinders must be completely extended or the LHS must
be completely stowed using AUTO mode before the MRP can be loaded.
Failure to
comply may result in damage to equipment.
NOTE
LHS will only operate when transmission range selector is in N (Neutral).
14.
Turn hydraulic selector switch (6) to MAN MAIN FRAME position.
15.
Move joystick (7) to UNLOAD position and hold until lift hook (9) has moved below level of hook bar (2).
16.
Apply service brake pedal (3) and set transmission range selector (1) to R (Reverse). Back vehicle up to
MRP, alining vehicle and MRP as straight as possible with lift hook (9) to middle of hook bar (2).
17.
Stop vehicle when lift hook (9) touches MRP.
18.
Set transmission range selector (1) to N (Neutral).
THAAD0282A
Back to Top
