TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 284 of 1616

TM 9-2320-440-13&P

0030-10

0030

LHS CAB CONTROL FAILS SELF TEST OR NO VIM HEART BEAT INDICATION (CONTINUED)

THAAD0527

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

NOTE

•

The THAAD communication harnesses have J1939 terminator resisters at the LHS cab

controller and input module Y connectors. The THAAD communication harnesses must

be disconnected from Y connectors as noted in Steps 17 through 23.

Failure to

disconnect THAAD communication harness from Y connectors will cause incorrect

results.

•

To locate the THAAD communication harness Y connector for the VIM No. 1, follow the

three-conductor harness back from the VIM No. 1, 40 pin connector terminals 21 and 22

to the communication harness Y connector.

Step 17.

Disconnect THAAD control valve harness VIM 1, 40 pin connector (WP 0089) and

THAAD communication harness connectors for VIM No. 1. Check for no continuity

between (+) J1939 and (-) J1939 wires at VIM No. 1, 40 pin connector, terminals 22

and 21.

If there is continuity, repair J1939 wires (TM 9-2320-325-14&P) or replace

THAAD control valve harness (WP 0088).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION