TM-9-2330-238-14
CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 1992
TM-9-2330-238-14 - Page 326 of 462
TM
9-2330-238-14
5-11.
LANDING
GEAR
MAINTENANCE
(EARLY MODEL)
(Con’t).
27.
Remove
two retaining
rings (61) and lubrication
fitting
(60) from pin (62). Discard
retaining
rings and lubrication
fittings.
NOTE
Note
position
of pin for installation.
Lubrication
fitting end of pin is roadside.
28.
Drive out pin (62) and remove
roller
(64) with two bearing
sleeves
(63) assembled.
29.
Remove
four
capscrews
(56) and
Iockwashers
(57) from two remote
control
levers (53) and roller
arms (5).
Discard
Iockwashers.
30.
Work two remote
control
levers (53) away from
roller arms (5) and past four woodruff
keys
(52).
31.
Remove
four woodruff
keys
(52) from cross
shaft (8).
32.
Remove
two
roller
arms (5) from
cross
shaft (8).
33.
Remove
bearing
block
(7) with two assembled
sleeve
bearings
(54) from cross
shaft (8). Remove
lubrication
fittings
(55) from bearing
block
and discard.
34.
Remove
capscrew
(59) and nut (58) from each
roller arm (5).
35.
If damaged,
remove
two sleeve
bearings
(54) from bearing
block
(7) and two sleeve
bearings
(63) from roller
(64).
1.
If removed,
install
two
sleeve
bearings
(63) in roller
(64) and two
sleeve
bearings
(54) in bearing
block
(7).
2.
Install
new lubrication
fitting
(55) in bearing
block
(7). Install bearing
block
on cross
shaft (8). Install two roller
arms (5) on cross
shaft,
one on each
side
of bearing
block.
TA702072
5-24
Back to Top
