TM-9-2330-238-14
CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 1992
TM-9-2330-238-14 - Page 327 of 462
TM
9-2330-238-14
5-11.
LANDING
GEAR
MAINTENANCE
(EARLY MODEL)
(Con’t).
3.
4.
5.
6.
7.
8.
9.
10.
11.
13.
14.
15.
16.
Position
four woodruff
keys
(52) on cross
shaft (8) in their respective
slots.
Install two remote
control
levers
(53), with
bosses
toward
the outside,
on each
end of cross
shaft
(8) past
woodruff
keys
(52).
NOTE
Four capscrews
will be fully tightened
during adjustment
of landing
gear
(subpara
c).
Secure two remote control
levers (53) to roller arms (5) with four new Iockwashers
(57) and capscrews
(56). DO
NOT fully tighten
capscrews.
Install
capscrew
(59) and nut (58) in each
roller arm (5).
Position
roller
(64) with assembled
sleeve
bearings
(63) between
two roller arms
(5).
Install
pin
(62), in position
noted
during
removal,
through
two roller
arms (5) and roller
(64). Install two new
retaining
rings
(61) on ends
of pin.
Install
new lubrication
fitting
(60) in roadside
end
of pin (62).
Install
new
lubrication
fitting
(49) in lower
brace
(25).
Install two
sleeve
bearings
(48)
in lower
brace
(25).
Install
new
lubrication
fitting
(50) in brace
hinge
pin (24).
Install
sleeve
bearing
(51) in upper
brace
(18).
Install two new lubrication
fittings
(47) in semitrail-
er bracket
(2).
Position
upper brace (18) at semitrailer
bracket (2)
and install
two sleeve
bearings
(46).
Repeat steps
10-15 for semitrailer
bracket
(2) and
upper and lower braces
(18 and 25) on other side.
TA702073
5-25
Back to Top
