TRANSFER CONTAINER FROM TRAILER TO VEHICLE - Continued
WARNING
•
Prior to and during the unload cycle, all personnel should stay
clear of LHS and container. Failure to comply may result in injury
or death to personnel.
•
Do not attempt unloading operations on a side slope greater than
5 degrees and/or fore/aft slope greater than 20 percent. Before
attempting to unload on slopes you must determine if ground
surface conditions permit safe unloading operations. Slopes that
contain snow, ice, loose gravel, or sand may not permit safe
unloading. Failure to comply may result in injury or death to
personnel.
CAUTION
•
Trailer drawbar must be fully retracted and lowered before
starting the unload process. Failure to comply may result in
damage to equipment.
•
Use extreme caution when unloading container with side doors.
Container must remain centered and doors must be closed at all
times. Failure to comply may result in damage to equipment.
•
ECHU needs to be in stowed position prior to unloading, refer to
TB 9-3950-253-13&P (WP
0057). Failure to comply may result
in damage to equipment.
1.
Fully retract and lower trailer drawbar (WP
0011) and stow cables.
2.
Remove lynch pin (Figure 21, Item 1) from clevis pin (Figure 21, Item 4).
TM 9-2330-342-10
0027
0027-25