TM-9-2330-342-10
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; OPERATOR'S MANUAL
SEPTEMBER 2012
TM-9-2330-342-10 - Page 304 of 500
TRANSFER CONTAINER FROM TRAILER TO VEHICLE - Continued
CAUTION
ISO locks must be fully unlocked from container. Failure to comply may
result in damage to equipment.
28.
Ensure that both ISO locks (Figure 26, Item 5) are fully unlocked.
29.
Stow two crank handles (Figure 26, Item 1) in BII stowage box (Figure 26, Item 2).
30.
Install two lower locking plates of FLA on container (Figure 26, Item 3). Refer to TB
9-3950-253-13&P (WP
0057).
CAUTION
Ensure bumper attachment is under bumper plate flange and at least one
of the bumper points is contacting the bumper plate. The bumper point
not contacting the bumper plate cannot exceed 0.5 in. (12.7 mm) distance
from bumper plate or container will not load properly. If bumper is not
under bumper plate flange or one of the bumper points is not contacting
the bumper plate, perform Steps (12) through (18). Failure to comply may
result in damage to equipment.
31.
Turn hydraulic selector switch to MAN H.A. position. Refer to vehicle Operator's
manual (WP
0057).
WARNING
•
Check for overhead power lines or other obstructions before
attempting LHS operation. Failure to comply may result in injury
or death to personnel.
•
Ensure all personnel are clear of the vehicle, trailer, and
container during LHS operations. Failure to comply may result in
injury or death to personnel.
CAUTION
•
Ensure trailer bumper attachment remains under vehicle bumper
plate during unloading process. Failure to comply may result in
damage to equipment.
•
Trailer must be unloaded in Manual Mode. Failure to comply may
result in damage to equipment.
TM 9-2330-342-10
0027
0027-32
Back to Top
