TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

  TM-9-2330-356-14 - Page 203 of 528

TM 9-2330-356-14
(b)
Loosen
both conduit connectors
(fig. 4-44).
(c)
Remove two capscrews and nuts that
secure conduit mounting plate to engine mounting frame.
(d)
Remove mounting plate and conduit.
(2)
Installation.
(a)
Install conduit connectors (fig. 4-44) if
they were removed.
(b)
Place end of conduit in conduit
connector attached to control panel.
(c)
Insert other end of conduit into
connector in mounting plate and attach plate to frame
with two capscrews and nuts.
(d)
Tighten conduit connectors to secure
conduit in place.
(e)
Install wiring harness (step b).
4-26.
Control Panel Light (Fig. 4-45)
a.
Replacement of Lamp.
WARNING
When troubleshooting an electrical malfunc-
tion or performing electrical maintenance,
ALWAYS disconnect intervehicular electrical
cable from semitrailer, and negative battery
cables at batteries. Failure to follow this warn-
ing may create a spark and explosion, result-
ing In serious injury or death to personnel.
CAUTION
Be careful not to crack lens by prying too hard
with screwdriver.
(1)
(2)
lamp.
(3)
(4)
Using a screwdriver, loosen lens from body.
Press down on lamp, and turn to remove
Replace lamp.
Press lens into light body.
b.
Removal.
(1) Open control panel (para 4-24).
(2) Disconnect terminal (fig. 4-45) from control
panel wiring harness.
(3) Remove terminal from electrical lead.
(4) Remove conduit connector (fig. 4-45) from
each end of tubing between control panel and light
assembly.
(5) Remove two screws and nuts which fasten
light assembly to hose trough.
(6) Remove light and pull wire from conduit.
Figure 4-45. Control Panel Light Installation.
4-67


Back to Top