TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 202 of 528

TM 9-2330-356-14

Figure 4-44. Control Panel Conduit Installation.

(2)

Installation.

(a)

Tape together all loose wires on control

panel end of new harness.

(b)

Coat entire harness with silicon or a mild

soap solution.

(c)

Attach new harness to cord that is in the

conduit.

(d)

Pull wiring harness through conduit

using the cord until end of harness is in control panel box

and leads are long enough to reach panel wiring leads and

jumper assemblies.

(e)

Remove cord

install new terminals to wires.

from end of harness and

CAUTION

Be sure leads and jumpers are properly con-

nected.

(f)

Connect harness wires to control panel

leads and jumper assemblies.

(g)

Close control panel and install six round

head screws. Be sure tubing to gages is not folded or

crimped.

(h)

Connect wiring harness to engine

junction box (fig. 4-44).

c.

Replacement of Control Panel to Engine Junction

Box Conduit.

(1)

Removal.

(a)

Remove control panel wiring harness

(step

b).

4-66