TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 790 of 1364

TM 9-2350-238-20-1

2-129. MAINTENANCE OF FINAL DRIVE ASSEMBLY (CONT).

1

Install two plugs (1), bolt (2), and pin (3) in final drive assembly (4).

2

Install two headless shoulder pins into holes located 180 degrees apart.

3

Install final drive lifting sling by inserting sling dowel into bolt mounting hole and placing lifting

eye (5) over stud (6). Install nut (7) on stud (6).

4

Install shaft nut (8) and lock ring (9).

5

Clean hull-to-final drive mating surfaces (10) with dry cleaning solvent and wire brush. Dry with

low-pressure compressed air.

6

Coat mating surfaces (10) with sealing compound.

7

Attach hoist to final drive lifting sling.

8

Install final drive (4) using hoist. Guide into position on hull using headless shoulder pins.

2-764