WARNING
TM 9-2350-238-20- 2
Table 2-2. PREVENTIVE MAINTENANCE CHECKS AND SERVICES WITH LUBRICATIO N
INSTRUCTIONS FOR M578 RECOVERY VEHICLE (CONT )
Item
No.
11
1 2
Interval
Q
Q
Item To Check/
Service
Traversing
Ring Gear
Turret Bearing
Procedure
CIean with CLP (item 5, appx C) and coat with
grease (item 12, appx C).
Make sure no personnel are in turret well
before traversing cab.
Lubricate quarterly, after 75 hours of operation, or
after each cleaning operation, when turret well is
exposed to steam or high-pressure water.
a.
Apply grease (item 12, appx C) to both lubrica-
tion fittings (1) until clean grease is observed at
seals (2).
b. Wipe away dirty grease that is forced through
seals.
c.
Repeat until only clean grease is observed at
seals.
d. Traverse cab four complete revolutions, alter-
nating left and right.
Not Fully Mission
Capable If:
Change 1
2-10.1 1