TM 9-2350-238-34-1
Section IV. WIRING HARNESS AND CABLE REPAI R
2-11. GENERAL.
This section contains instructions on repair of wiring harnesses and cables
(leads). Repair of wiring harnesses and cables consists of replacement of defective connectors,
shells, and terminals, or taping cut or worn insulation and exposed wire conductors. Pages 2-21 thru
2-28 show exploded views of typical harness and cable connectors used on the vehicle, and give
procedures for disassembly and assembly of connectors. When soldering is required, procedures i n
TB-SIG-222 must be followed .
INITIAL SETU P
Tools and Special Tools
Automotive maintenance and repair shop equipment: field maintenance, basic, less power
(SC 4910-95-A31 )
●
Electric soldering iron
●
Electrical repair tool kit
Materials/Part s
Solder (item 28, appx B)
NOT E
Label cables on multiple receptacles during disassembly to ensure proper order during
reassembly .
2-12. TYPICAL FEMALE-TYPE PANEL MOUNTING RECEPTACLE CONNECTOR .
DISASSEMBL Y
1
2
3
Drive socket contacts (1) out through rear of
insert (2) with pin extractor.
Unsolder cable leads from solder wells on
socket contacts (1).
Slide insert out through rear of shell
assembly (3) .
2-21