TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 558 of 796

Table 1.

Operator Preventive Maintenance Checks and Services (PMCS) – After - Continued.

ITEM

NO.

INTERVAL

ITEM TO BE

CHECKED OR

SERVICED

PROCEDURE

EQUIPMENT

NOT READY/

AVAILABLE IF:

25

AFTER

Track Adjusting

Links

NOTE

The following steps cover both new and old

configurations. New configuration is shown

in figure.

1. Check for broken or missing link assemblies.

Link assembly broken,

missing, or damaged.

2. Check for broken or missing cotter pins.

3. Check for broken or missing connector pin and

retainer bolts.

Connector pin or nut

broken or missing.

Figure 18.

Track Adjusting Link.

26

AFTER

Track Tension

1. Check track tension (old configuration (WP 0109) or

new configuration (WP 0110)) and adjust as required.

Track tension will not

adjust.

27

AFTER

Hull Access

Covers and

Access Plates

CAUTION

If vehicle is being parked for an extended

period of time (2 weeks or longer), both hull

drains must be left open, all five hull access

plates must be removed, and engine deck

area must be covered. Failure to comply

may result in damage to vehicle due to

excessive water build-up in vehicle engine

compartment.

NOTE

If boom is in RAISE position, lower boom to

STOWED position (WP 0078).

1. Open both vehicle hull drains. Allow vehicle hull to

drain.

2. Ensure drains are clear and free of debris. Clean, if

required.

TM 9-2350-256-10

0098

0098-20