TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 608 of 796

TRANSMISSION OIL SAMPLING

NOTE

For sampling instructions, refer to AOAP TB 43-0211 (WP 0131) prior to performing

Step 1.

1.

Open engine deck exhaust grille and exhaust deflector (WP 0029).

2.

Remove protective cap from sampling valve (Figure 2).

3.

Position sample collection bottle under sampling valve (Figure 2).

WARNING

•

Hot surfaces can ignite engine oil. Clean oil from and around sampling area with

wiping rags. Failure to comply may result in personnel death, injury, and/or

damage to equipment.

•

Surface may be HOT on contact and cause burns to exposed skin. Do not touch

surface with bare hands. Failure to comply may result in personnel injury.

4.

Lift oil sampling valve lever and fill bottle to required level.

CAUTION

Ensure oil sampling valve is parallel to oil filter cover and that protective cap is installed

and secured on sampling valve. Failure to properly position oil sampling valve lever and

secure protective cap may result in loss of engine oil and damage to equipment.

5.

Install protective cap on sampling valve (Figure 2).

6.

Close engine deck exhaust grille and exhaust deflector (WP 0029).

TM 9-2350-256-10

0101

0101-6