Table 1.
Operator Preventive Maintenance Checks and Services (PMCS) – Monthly - Continued.
ITEM
NO.
INTERVAL
ITEM TO BE
CHECKED OR
SERVICED
PROCEDURE
EQUIPMENT
NOT READY/
AVAILABLE IF:
28
MONTHLY
Brake Slack
Adjuster and
Brake Rod
Clevis
NOTE
Two fittings are located on mechanic and
operator side of vehicle.
1. Remove drain covers (brake adjustment access
covers).
2. Lubricate two brake slack adjusters and two brake
rod clevises through four fittings until grease is visible
(WP 0101).
NOTE
Brake pedal must be fully applied to ensure
accurate brake adjustment reading.
3. Ensure brake adjustment indicator (marked on brake
linkage) is aligned with brake adjustment indicator rod,
which is attached to transmission guide rails. Repeat
procedure for other side. If brake adjustment indicator
is not aligned, notify maintenance.
4. Install drain covers.
Figure 29.
Brake Slack Adjuster and Brake Rod Clevis.
PMCS MANDATORY REPLACEMENT PARTS LIST
There are no replacement parts required for these PMCS procedures.
END OF TASK
END OF WORK PACKAGE
TM 9-2350-256-10
0100
0100-18