TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 125 of 772

TM 9-2350-260-20-1-2

DRAIN ENGINE OIL (2A ENGINE) (Sheet 2 of 2)

4.

Position container under drain valve opening.

5.

Cut lockwire from drain plugs (F).

6.

Using ratchet and extension, remove two oil drain

plugs (F) from engine oil pan (G).

7.

Allow engine oil to drain into container.

8.

After draining, using rags (Item 65, Appendix D),

clean area around drain plugs (F) and, using

ratchet and extension, install drain plugs (F) into

engine oil pan (G).

9.

Using lockwire (Item 59, Appendix D), safety wire

drain plugs (F).

10.

Refill crankcase (LO 9-2350-260-12).

11.

Line up four holes in valve seat (A), new gasket

(E), and hull floor (C) under tank.

12.

Using 3/4 inch socket install four screws (B) and

new lockwashers (D) holding valve seat (A) and

gasket (E) to hull floor (C).

13.

Operate rear drain valve to make sure valve opens

and closes smoothly.

If valve does not open or

close properly, remove, inspect and install valve

assembly again.

End of Task

TA147502

6-48