TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 16 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2A ENGINE) (Sheet 5 of 24)
13.
Reaching through upper engine access cover
opening, use 7/16 inch wrench to remove bolt (M)
holding accelerator linkage clevis (N) to rod end
(P).
Lift and displace rod end.
14.
Reaching through lower engine access opening,
use spanner wrench to loosen four connectors
(Q).
Manually disconnect connectors.
17.
Using 7/16 inch wrench, loosen nuts of outer
clamp (R) holding air cleaner outlet hoses (S) on
each side to air cleaner.
18.
Remove clamps and manually displace two air
cleaner outlet hoses (S) (each side of tank).
19.
Put protective coverings over outlet hose connect
point (T).
15.
Using heavy masking tape (Item 57, Appendix D),
fasten four loose electrical cables to bulkhead.
NOTE
Make sure tied-off line is clear when
traversing turret.
16.
Close grille doors and manually traverse turret to
bring gun tube over left or right fender box
(TM 9-2350-260-10).
Open grille doors.
Go on to Sheet 6
TA147907
5-6
Back to Top
