TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 21 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2A ENGINE) (Sheet 10 of 24)
NOTE
When removing screw (AP), hold onto quick-
disconnect ring (AQ), or it will snap open and
fall down into engine compartment.
36.
Using 3/4 inch socket, remove screw (AP)
securing quick-disconnect ring (AQ).
37.
Remove both rings (AQ).
38.
Using hammer and pinch bar, tap final drive
adapter (AR) toward final drive each side of tank
far enough to free adapter from universal joint.
NOTE
Continue tapping final drive adapter
(it will move 1-1/2 inches) until gears
release.
39.
Hang two fabricated final drive guide shields (Fig.
1, Appendix F) (one on each side of tank) at final
drive universal joints (AS) to prevent hangups
when powerplant is removed.
Go on to Sheet 11
TA147912
5-11
Back to Top
