TM 9-2350-260-20-1-2
TRANSMISSION OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 1 of 10)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
6-145
Installation
6-149
TOOLS:
1/2 in. socket with 1/2 in, drive
6 in. extension with 1/2 in. drive
Ratchet with 1/2 in. drive
3/4 in. combination box and open end wrench
1-1/2 in. open end wrench
Flat-tip screwdriver
SPECIAL TOOLS:
Ground hop kit (Item 30, Chapter 3, Section I)
SUPPLIES:
Drip pan
Masking tape (Item 57, Appendix D)
Plastic barrier material (Item 41, Appendix D)
Rag (Item 65, Appendix D)
Cover for turbosupercharger air inlet port
Lockwasher (MS35335-34) (4 required)
REFERENCE:
LO 9-235026012
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-27)
Remove engine shroud (page 9-2)
NOTE
Right side shown, left side similar.
Go on to Sheet 2
TA147595
6-144