TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 211 of 772

TM 9-2350-260-20-1-2

TRANSMISSION OIL COOLER REPLACEMENT (2A ENGINE) (Sheet 1 of 10)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

6-135

Installation

6-140

TOOLS:

1/2 in. combination box and open end wrench

1-1/2 in. combination box and open end wrench

Diagonal cutting pliers

Flat-tip screwdriver

1/2 in. socket with 1/2 in. drive

9/16 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

1-3/4 in. open end wrench

9/16 in. combination box and open end wrench

1-5/8 in. combination box and open end wrench

Slip joint pliers

SPECIAL TOOLS:

Ground hop kit (Item 30, Chapter 3, Section I)

SUPPLIES:

Masking tape (Item 57, Appendix D)

Plastic barrier material (Item 41, Appendix D)

Transmission oil cooler bypass valve gasket (NAS1598-6V)

Lockwire (Item 60, Appendix D)

Shroud-to-oil-cooler lockwasher (

) (2 required)

REFERENCES:

TM 9-2350-260-10

LO 9-2350-260-12

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-2)

Remove engine shroud (page 9-2)

Go on to Sheet 2

TA147585

6-134